Yakima SKS Control/Change Key - For insertion or removal of Yakima SKS lock cores

The Yakima SKS Control/Change Key is used to insert or remove Yakima SKS (Same Key System) lock cores from Yakima lock housings. It works by dropping all of the locking tabs to one side of the lock core, including the rearmost tab. The Yakima SKS Control/Change Key only works on lock cores in the unlocked position. If you are trying to remove or swap a lock that is in the locked position, you must first unlock it using your like-numbered Yakima key.

To install a lock core into a lock housing:

1. Insert the Yakima SKS Control/Change Key into the lock core
   
2. Align the cylinder alignment tab on the back of the lock core with the corresponding circular opening inside of the lock housing
   
3. Insert the lock core with Yakima SKS Control/Change Key into the lock housing
   
4. With your finger holding the lock core in place, remove the Yakima SKS Control/Change Key
   
5. Your lock core is now installed and can be locked and unlocked with your regular Yakima keys

To remove a lock core from a lock housing:

1. Make sure the lock core you are trying to remove is in the unlocked position (or in the case of rooftop boxes, turned to the half point removal angle)
   
2. Insert the Yakima SKS Control/Change Key into the lock core
   
3. Wiggle the lock core out using the Yakima SKS Control/Change Key

Features

• Yakima SKS Control/Change Key is used to insert or remove Yakima SKS lock cores from Yakima lock housings
  
• Yaima lock cores with keys combination packs come with one Yakima SKS Control/Change Key in them
  
• SKU: 8007835
  
• Manufacturer: Yakima